Kantronics MT1200
Specifications
| Dimensions (H×W×D) | 0.95"×4.9"×3.0" (24 mm × 125 mm × 76 mm) (including mounting tabs) |
|---|---|
| Weight | 4.8 oz (0.136 kg) |
| Power Requirements | |
| Voltage | DC 12 V nominal |
| Current | < 35 mA (LEDs on, unit active, no GPS) <75 mA (LEDs on, GPS active w/antenna) |
| External Power Connector | RIA Connect RIACON series, type 169, 3 pin (31169103) |
| External Signal Ports | DB-9 female (radio port) DB-9 female (computer/data terminal) Telemetry plug - RIA Connect PlugCon series, type 374, 10 pin (ASP05110) |
| Analog Measurement Inputs (A/D Converter) | Two inputs; 0 V to +3.3 V, 8-bit accuracy |
| Radio Port | |
| Data Rate | 1200 bps |
| External Carrier Detect | Pulldown to ground (normal or inverted) |
| PTT Output | Open drain, max +60 V dc, max 115 mA max |
| Audio Output: | |
| Level | Continuously adjustable from 1 mV p-p to 1.7 V p-p |
| Output Impedance | 600 Ohm, AC coupled |
| Modulation | 1200 bps FSK half duplex, Bell 202 1200 Hz/2200 Hz |
| Audio Input: | |
| Input Sensitivity | 5 mV p-p |
| Input Dynamic Range | > 70 dB |
| Input Impedance | Unbalanced, 10 kOhm (600 Ohm with jumper J3 installed) |
| Max Input Voltage | ±12 V dc; 35 V p-p sinusoidal |
| General | |
| Operating Modes | AX.25, KISS, XKISS, Linesub, MODEM, POLL, TUP |
| LED Indicators | Power, Xmit, Rcv, Connected, Status, GPS Ant, GPS Valid (user option on/off) |
| Remote Control Access | All controller functions, user-defined password |
| Operating Protocols | AX.25 Levels 1 and 2 (user-selectable) |
| Embedded GPS Receiver (MT1200G only) | |
| Type | Trimble Lassen iQ GPS module |
| Operational (COCOM) Limits
Altitude Velocity |
18,000 m 515 m/s Note: either may be exceeded, but not both. |
| General | L1 (1575.42 Mhz) frequency, C/A code, 12-channel, continuous tracking receiver. |
| Accuracy
Horizontal Altitude Velocity |
< 5 m (50 %), < 8 m (90 %) < 10 m (50 %), < 16 m (90 %) 0.06 m/s |
| Acquisition times
Reacquisition Hot Start Warm Start Cold Start |
(Autonomous Operation in Standard Sensitivity Mode)
< 2 s (90 %) < 10 s (50 %), < 13 s (90 %) < 38 s (50 %), < 42 s (90 %) < 50 s (50 %), < 84 s (90 %) Cold start requires no initialization. Warm start implies last position, time, and almanac are saved by backup power. Hot start implies ephemeris also saved. |
Specifications subject to change without notice or obligation.
APRS® is a registered trademark of Bob Bruninga, WB4APR.
Send e-mail to dx@universal-radio.com
Copyright 2007, Universal Radio, Inc.