RIGblaster Plus II Specifications

RIGblaster Plus II
Specifications

Sound Card Interfaces

RIGblaster Plus II Specifications

Overall Dimensions (maximum, w/o cables)	1.5 H x 5.5 W x 5.75 D inches
Weight (without AC adapter)	9 oz.
AC Power requirements (with supplied AC adapter)	120 VAC <1.5 watts
DC Power requirements (without supplied AC adapter)	13.8 VDC nominal < 80mA
Frequency response, microphone input	Direct coupled
Distortion, microphone input	Direct coupled
Frequency response sound card input	100 Hz - 15 kHz, ± 1dB
Distortion sound card input	Less than 0.1 % THD @ 1 kHz
Input impedance (from sound card)	600 ohms resistive, minimum
Sound card level adjustment range	-34 dB to > -120 dB
PTT max contact rating	2 A @ 24 V or 1 A @ 48 V
CW or FSK direct keying ratings	Transistor logic only, tube amps not supported. Positive pull down .15 V min. @ 20 ma. max
Serial interface (DB9F connector)	Standard RS232
RS232 Pin Assignments (DB9 PC signal set) Pin 4 Data Terminal Ready (default Keying control) Pin 5 Signal Ground (isolated digital common) Pin 6 Data Set Ready (PTT interrupt) Pin 7 Request To Send (default PTT control) Pin 8 Clear To Send (PTT interrupt)
The microphone audio is completely isolated from all other grounds. The sound card audio is isolated using an audio transformer. The serial and PTT circuits are isolated using, two DPDT relays, and an opto-isolator. A high grade DC blocking capacitor on sound card to mic. output is provided for use with radios that are designed for use with amplified or electret microphones. The relays provide adequate current and voltage capability to switch tube rigs. The relays also provide automatic switching between sound card audio and the microphone plus our mic. override and mic. interrupt features.