Icom RS-BA1 v2
Remote Software

 

 

The Icom RS-BA1 v2 IP Remote Control Software allows you to use an Icom compatible radio installed in another room using your home network or even from a remote location over the Internet. Most functions and modes of your Icom compatible transceiver can be controlled, including interference rejection functions and IF filter settings. Low voice latency (caused by the RS-BA1) provides the same operational experience as using an actual radio. The S-Meter and SWR can even be observed.

With the RS-BA1 Version 2, you can use the dual watch operation and spectrum scopes with waterfall function as well as observe the MAIN and SUB spectrum scopes. The RS-BA1 Version 2 can also enlarge the panel size (normal or large is selectable), [MUTE] buttons added, clickable indicators to change settings, SUB dial added and RIT tuning knob & TX functions added. The RS-BA1 Version 2 can also still be used with single-receiver transceivers. Shown above in use with a dual-receive transceiver.

The RS-BA1 Windows® CD consists of two component software applications:
1. System configuration software sets up IP address, audio sampling rate and other settings.
2. Remote control software provides a user interface, similar to the radio's front panel, and allows you to control the radio from a remote location.

The IC-9700 can be connected to a PC via a USB cable and the input/output audio signal and CI-V command is sent through the USB cable.
This software is designed to operate with Windows® 7, Windows® 8.1 and Windows® 10 on a PC with 1.8 GHz processor or better, 150 Mb HD, 1024x768 resolution.

The exact capabilities of this device varies by radio model.